BitterCare,
here's how to use it.
Cover the full contact area with a little extra, and keep edges flat. Placement and adhesion matter.
Four steps for the first day.
Clean, cut, apply and observe. Follow them in order.
Clean the surface
Remove dust and oil, then dry completely to help the adhesive hold.
Cut to size
Cut slightly larger than the area actually chewed.
Apply at the contact point
Remove the backing and press firmly onto the actual contact area with no lifted edges.
Observe the response
Observe over the first few days, adjust placement and replace with a new sticker if needed.
If the backing is hard to peel.
Check the photo instructions. When using a blade, work on a flat surface and take care not to injure your hands or damage the product.
Cut the length needed
Leave a little extra around the application area for a neat finish.
Lightly score the surface
Make a very shallow score where separation is needed. Do not cut through the product or cut while holding it in your hand.
Gently separate the layers
Starting at the scored area, gently open and separate with both hands.
Five practical tips.
Check placement, coverage and adhesion before use.
Press down with no lifted edges
Cover the area generously
Check the printed bitter surface
Do not offer directly to taste
Wrap cords in short sections
Tap a picture to enlarge. On mobile, swipe to view all five tips.
BitterCare is not electrical insulation or shock protection. Do not use on damaged cords; unplug before applying.
Responses may vary by dog.
Response depends on bitter-taste sensitivity, chewing habits, contact point and environment. BitterCare supports behavior management. Observe and adjust placement at first.
Check the application spot
before you begin.
The key is applying it to the household surface your dog actually mouths: furniture, door frames or cord-protection areas.
A little help, whenever you need it.
Questions about placement or the product? Tell us what is happening and we will reply by email after reviewing your message.